NAME OF WHEEL PARTS




WHEEL SIZE






OFFSET

The offset indicates the distance from the center of the rim to the attaching disk part (unit:m/m). As seen in the attached drawing, the offset is indicated by "+" when the fitting surface extends beyond the central line of the rim and "-" when it is falls within. Caution is required to prevent the tire from coming into contact with the fender of the vehicle or the brake caliper if the offsets are very different.



P.C.D

The number of bolts used to install a wheel varies from 4 to 6 depending on the vehicle model (except for some vehicle type), thus the wheel to be installed should also possess the same number of hub bolt holes. P.C.D. stands for pitch circle diameter, and indicates the diameter of the circle in mm connecting the center of each hub bolt. Since the P.C.D. also varies according to the vehicle model, make sure a suitable one is selected.



CLEARANCE

Fender clearance indicates the marginal space between the tire and the fender or body of the vehicle. Inner clearance indicates the distance between the tire and wheel and the body part which is positioned close-set to the tire and wheel. Dimensions for both right and left clearance should be measured on a level surface, and the smaller value is then considered as the inner clearance.



TIRE SIZE

1-Tire width (mm or inch) 2-Aspect ratio 3-Radial construction 4-Rim diameter 5-Load index 6-Speed symbol 7-Tire outer diameter (inch) 8-Ply rating

你們也是做輪圈的產業???
亞獵士???

是很像pizza製程的產業

亞獵士是我們客戶耶

ㄚ修是做啥的啊??

哈囉....安阿



我們是做西工的阿

什麼是西工的啊??
不懂耶= =

各式機械架構阿